Random good picture Not show

1. The surface of bed uses an import cold plate ramming formation, the surface eliminates the rust, the static electricity spraying, the anti-aging, does not rust.

2. This paper introduces the design method that uses cold plate technique to cooling of hermetically sealed transmitter. It gives the calculation process of the design method deduced from theory.

3. Experimental study shows that the heat pipe cold plate equipment possesses excellent heat transfer performance and temperature evenness, and satisfies design requirements.

4. The static heat load and the cold plate temperature of the cryostat were tested, the experimental results show that the cryostat is fit for the served laser.

5. The cold plate cooling system with an external finned heat sink for the drive system in ring spinning frames is described.

5. Sentencedict.com is a online sentence dictionary, on which you can find excellent sentences for a large number of words.

6. Material: fitting the high intensity cold plate, the surface spray; Matt reflector using quality aluminum; Stall use of aluminum shafts starting grid.

7. At the same time, the average heat exchange coefficient and the pressure loss of the cold plate have been tested.

8. It is also found that the most important factors that influence the frost growth are the temperature of cold plate and relative humidity of air.

9. The article describes the features of off - set 8 - h cold plate mill on structure and technique.

10. The material is usually made of stainless steel, or spray painting of superior cold plate.

11. Because of the influences of such factors as machining tolerance etc. , the contact thermal resistance between chip and cold plate can't be controlled effectively.

12. Moreover, Japan as the largest exporter for China and China's 47% products concentrated in the high-end cold plate, steel and other varieties come from Japan.

13. The numerical solution shows that temperature distribution rule on every cross-section of cold plate agree with conclusions of theory analysis.

14. When total heating power P or cooling water flow rate Q increases, heat transfer performance of the heat pipe cold plate is enhanced and R(subscript th) decreases under experimental tilt obliquities.

15. The experimental results demonstrate that this coating could restrain the frost growth in the condition of lower relative humidity and higher cold plate temperature.

16. To make full use of the new designed heat pipe cold plate, cooling conditions in condense segment and corresponding heating conditions in evaporation segment must be managed.

17. The article describes the automatic gauge control, cause of thickness deviation, setup of control models and thickness control and adjustment of the single stand cold plate mills.

18. Introduce 4 kinds of heat-sinking designs of printed circuits in aircraft electronic device:swash, cold plate, plate hot tube and hollow plate.

19. They smile in the face so that you feel is a cold plate of leftovers.

20. The cooling problem of solid state active phased array radar is discussed in this paper. And the type of a high efficient cold plate with plate fin that is suitable for T /R module is introduced .